Onan Remote Start Switch Wiring Diagram

The Onan remote start switch is a convenient way to start your generator from a distance. It can be used to start the generator in case of an emergency, or to simply warm it up before you get in your vehicle. The remote start switch is wired to the generator's starter solenoid, which is responsible for turning the engine over. When you press the remote start button, the switch sends a signal to the starter solenoid, which then engages and starts the engine.

The Onan remote start switch is a relatively simple device, but it is important to install it correctly in order to ensure that it works properly. The following instructions will walk you through the process of installing the Onan remote start switch:

Locate the starter solenoid on your generator. The starter solenoid is typically located near the engine.
Disconnect the negative battery cable from the battery.
Trace the wires from the starter solenoid to the ignition switch.
Cut the wires leading from the starter solenoid to the ignition switch.
Strip the ends of the wires and connect them to the terminals on the remote start switch.
Secure the remote start switch in place.
Reconnect the negative battery cable to the battery.

Once the remote start switch is installed, you can test it by pressing the remote start button. The engine should start up and run for a few seconds before shutting off. If the engine does not start, check the wiring to make sure that it is connected correctly.

The Onan remote start switch is a convenient and easy-to-use way to start your generator from a distance. By following these instructions, you can install the remote start switch yourself and enjoy the benefits of being able to start your generator without having to get out of your vehicle.

Here is the wiring diagram for the Onan remote start switch:

532623m