Mk Water Heater Switch Wiring Diagram

MK Water Heater Switch Wiring Diagram

This article will provide you with a step-by-step guide on how to wire a MK water heater switch. This information is intended for use by experienced DIYers only. If you are not comfortable working with electricity, please consult a qualified electrician.

Before you begin, make sure that you have the following materials:

A MK water heater switch
A 12-gauge wire
A wire stripper
A screwdriver
A tape measure

Once you have gathered your materials, you can begin by turning off the power to the water heater. This can be done by either turning off the main breaker or by disconnecting the power cord from the outlet.

Next, you will need to locate the wiring terminals on the water heater. These terminals are typically located on the side of the water heater. There will be three terminals: one for the hot water line, one for the cold water line, and one for the power supply.

You will now need to strip the ends of the wires. The wire stripper should be set to a width that is slightly larger than the diameter of the wire. Strip about 1/2 inch of insulation from each end of the wire.

Now you can connect the wires to the terminals. The hot water line should be connected to the terminal labeled "H". The cold water line should be connected to the terminal labeled "C". The power supply should be connected to the terminal labeled "L".

Once the wires are connected, you can turn the power back on to the water heater. Test the water heater to make sure that it is working properly.

Here are some additional tips for wiring a MK water heater switch: